About how to seal the wiring of the underground light, listen to the LED underground light manufacturer to tell you. Since the underground light is different from the underwater light, the first thing to look at is whether its position is in low-lying water, so when wiring, the wiring must be waterproofed, and the following points should be paid attention to:

1. The wire junction box should be equipped with a waterproof junction box. Generally, our underground light junction box has a special sealing rubber ring and fixing parts. Insert the wire through the rubber ring, and then use stainless steel fasteners to tighten it, so that the wire cannot be pulled out from the sealing rubber ring.

2. The wiring of the buried lamp must correspond to the live wire and the neutral wire, and the ground wire should be connected firmly.

3. At the wiring point, after wiring is completed, tighten the nuts and screws on the box cover to ensure sealing.

4. During construction, the groundwater should penetrate well, and the junction box should not be flooded.