Select the installation site. Indoor and outdoor places with good ventilation, no corrosive gas in the air, no combustibles and less dust are suitable for installing LED lights. The rated voltage of the power supply of the LED lamp fluctuates in the range of +20% to -20%, and the electronic ballast may be burned if the rated voltage is exceeded.

  Second, the wires cannot be lengthened at will, especially the wires connecting the light bulbs.

   Third, LED light bulbs and ballasts should be used together, and the electric power should be the same, but the deviation is within the allowable range of about 10%.

   Fourth, for areas with cold winters or in outdoor places, the LED lamps used should be of high sealing level, and it is strictly forbidden to disassemble the cover of the lamps.

Fifth, before installing the LED lights, firstly connect the lamps, and then turn on the power to confirm that the lamps will be on, and then install the lamps to prevent the trouble caused by the inspection after the lights are not turned on due to transportation or other reasons after installation. .

   Sixth, to install the LED light, the wide side should be fastened to the side of the light-emitting mask, and the narrow side should be fastened to the lampshade.