LED street lamp debugging in the installation process is very important, so in the system debugging process of LED street lamp what are the small skills can be applied? Let's take a look at LED street lights in the system debugging tips.

LED street lamps should be comprehensively tested before factory installation to see whether LED street lamps can be lit, so as to avoid being found after hoisting and increase the cost of installation and debugging.

LED street lamp debugging skills

1. Set the time control function. According to the daily lighting time designed in the design scheme, set the time control point according to the instructions of the controller. The lighting time every night should not be higher than the design value, equal to or less than the design value.

2. Analog lighting control function. During the day, wiring can be done to completely block the solar array's luminous surface with an opaque object (or to remove wiring from the controller's battery components). According to the delay time mentioned in the controller manual (generally 5min), see whether the lamp can be automatically lit after the corresponding time. If it can be turned on, it indicates that the light control switch functions normally. If it cannot be enabled, the optical switch function is invalid. You need to check the controller Settings again.