Home
Products
About Us
Cases
News
Support
Contact us
Home  >  News  >  Industry news

Lighting lamp manufacturers share how to do waterproof work for LED high-power wall washer?

time:May 12, 2022 Views:


How should the LED high-power wall washer be waterproof? Only when the waterproofing of the lamps is done, the LED high-power wall washer can play its good effect and service life. The following Guangchen will explain the steps of production and installation of LED wall washer:

1. First, solder the LED lamp beads on the aluminum substrate with a soldering iron and a tin bar for use.

Lighting lamp manufacturers share how to do waterproof work for LED high-power wall washer?(图1)

2. The high-power wall washer with driver will drive the glue to ensure that the driver is 100% waterproof.


2. Then test the welded board to see if there is any virtual welding or no light, so that through preliminary aging, it can ensure that the drive and lamp beads of the LED wall washer are in good condition.


3. After the test lighting is completed, put heat-dissipating silica gel on the back of the aluminum base plate, and put the board into the shell.


4. The preparation process is done. Weld the power supply to the positive and negative poles of the aluminum substrate, and then bind the two ends with tape for glue filling.


5. After the glue is dry, cover the glass again. The structural waterproof wall washer does not need to be glued. It is not structurally waterproof and needs to be glued well.


6. After the glass is covered, plug the head.


7. The above steps have been completed, and the aging test should be carried out for 24 hours before packaging.


Why does the LED line light not light up after a long time? Back to list What factors are related to the life of led line lights