time:May 12, 2022 Views:
The led line light is the led wall washer series aluminum profile lamp body. The compact and lightweight end cover and mounting bracket are made of aluminum alloy high pressure die-casting high temperature resistant silicone rubber sealing ring to ensure waterproof reliability. Luminaires can be installed individually or in combination. Suitable for all kinds of buildings, indoor and outdoor local or contour lighting.
When it is raining or snowing, and when the light is turned off, the temperature in the led line lamp will drop sharply, and the sharp drop in temperature will cause an instantaneous pressure or even greater vacuum inside the lamp housing. At this time, air or moisture will sneak into the lamp body through the sealing gap and condense into water droplets. Once the water droplets are generated in the sealed lamp body, it is not easy to be discharged. Water droplets that cannot be discharged for a long time will corrode electronic components in the lamp body, which will seriously affect the life of the led line lamp.
If you don't need to consider the problem of drive and power supply failures, one of the manifestations of the life of high-power led line lights is: "light decay", which means that the longer the use time, the lower the brightness, until the life is exhausted. light.
The led line light usually uses aluminum as the radiator. The larger the contact area between the radiator and the air, the better, which is conducive to heat dissipation. The whole lamp works stably, with small light decay and long life; bulbs and ceiling spotlights should not have excessive ventilation. holes, so as to avoid mosquitoes crawling in during use, affecting the lighting effect or causing unnecessary damage.
For the glue filling problem, the silica gel under the glass surface should be thicker. If it is too thin, it will affect the solidification effect; secondly, many people ask what to do when the cover glass is used. Because of the different strengths, the amount of silica gel pressed under the glass is also different. Here we ask The only thing is to press it a little; there is also the question about the waterproof breathable valve, some high-end styles will be used. The principle of the waterproof breathable valve is to prevent water from entering and air can enter. This is in rainy days. The waterproof vent valve can speed up the temperature of the inside and outside of the lamp to be consistent, so that the pressure change will not be too drastic, avoid damage to the internal components of the lamp body, and it is also conducive to heat dissipation and accelerated air convection. Just these points, well-made LED linear lights can easily achieve the effect of IP65 or higher.