Home
Products
About Us
Cases
News
Support
Contact us
Home  >  News  >  Industry news

What should be done in the daily maintenance of outdoor LED wall washer?

time:May 10, 2022 Views:


With the development trend of lighting engineering, the traditional light source of lamps has long been unable to meet people's needs for lighting. Nowadays, LED wall washers are more and more loved by urban lighting. Except for the design of lamps, it has achieved lighting According to the requirements of the effect, the lighting display after the actual installation has also been loved by everyone. However, during the use of the construction site, the LED wall washer also needs to do the usual daily maintenance. Because this affects its service life. What do we need to do in our routine maintenance? The editor of Guangchen summarized 3 points to share with you.

What should be done in the daily maintenance of outdoor LED wall washer?(图1)

     Maintenance of outdoor led wall washer

          1. The first step is to turn off the switching power supply of the high-power led wall washer. This is an essential step in the maintenance of lighting fixtures. Doing so ensures that the entire maintenance process is absolutely safe and non-conductive. And it is not easy to cause damage to the power circuit of the lamp. So a power outage is a must. Then be sure to scrub with a dry towel when cleaning. Towels soaked with water will cause certain damage to the lamps. For example, water droplets leak into the inside of the lighting lamps. If the lamps themselves are powered by high voltage, the water droplets inside may conduct electricity after the power is turned on.

          2. Special attention in step 2 is that compounds cannot be used for scrubbing during cleaning, such as detergents, which have physical properties and usually cause erosion on the surface of the high-power led wall washer, and leak into the lamps. Reacts with the glue inside. cause a chemical reaction.

          3. Step 3 Regularly check whether the mounting bracket screws of the lamp are loose and whether the waterproof tape has fallen off where the wall washer is connected to the power supply. If it falls off after a long time, you can re-wrap it a few times.


"LED linear light" wiring method at both ends Back to list How to correctly and quickly choose led wall washer in lighting engineering