Home
Products
About Us
Cases
News
Support
Contact us
Home  >  News  >  Industry news

"LED linear light" wiring method at both ends

time:May 09, 2022 Views:


I believe that many friends are doing outdoor construction of LED line lights, how to connect the power supply when the LED tube is energized? Then Guangchen Lighting will reveal the wiring method of the two ends of the LED line light for you.

1. The side outlet of the wiring method of the two ends of the led line light:


Choose a surface from the side of the aluminum material at both ends of the linear light to punch a wire outlet hole about the size of the wire diameter. The waterproof wiring is connected to the circuit board from this hole position, and is threaded out from the side of the aluminum material. The advantage of installing it is that it can be done Seamless docking, no dark areas for lighting effect, and very convenient installation, but this installation method is not very convenient for hiding power lines and signal lines, and the lines can only be exposed outside. Not so pretty.

"LED linear light" wiring method at both ends(图1)

2. The plug outlet of the wiring method of the two ends of the led line:


The plug outlet is to open an outlet hole from the middle of the plug pieces at both ends of the LED line light. The LED outdoor waterproof linear light with a very plug outlet is different from the hidden wire at the bottom and the side outlet. There will be a gap between the lamp and the lamp during butt installation. The gap of about 1CM, in the practical application of lighting engineering, the spacing of 1CM will not have much impact on the overall lighting effect, because the beam is scattered and can fill the missing part of the light by itself. The plug outlet cannot be seamlessly connected, and the aesthetics is slightly inferior to that of the bottom outlet. It is used in dark grooves and glass curtain walls in various buildings. The advantage is that it is easy to install.


3. The bottom outlet of the aluminum material for the wiring method of the two ends of the led line light:


The bottom outlet is to wash a notch from each end of the aluminum profile of the linear light, and use the wire head with the tail card to deflate the tail card to the bottom.


"How much is the led line light" for the lighting of the outer wall of the community Back to list What should be done in the daily maintenance of outdoor LED wall washer?